1 – Add a Plant or Garden
Tap the + to add a new plant or a new garden at any time.
2 – Garden Settings
Here you can create a new garden, add existing plants to a garden, or move plants between gardens. You can also delete existing gardens.
3 – More Options
Tap the three dots in the top right for the following options:
Delete plants: Permanently remove plants from your garden.
Share plants: Share plants with other people – for collaborative care or so someone can look after your plants while you're on holiday.
4 – Parameter Symbols & Sorting
The symbols above the plant list represent the individual measurements – water, nutrients, light, temperature and humidity. They organise the readings below like table columns.
Tap a symbol to sort your plants by that parameter:
Tap once: Plants with the most urgent need for that parameter appear at the top.
Tap again: The order reverses – plants that need the least attention for that parameter appear at the top.
5 – Status Indicators
Next to each plant you'll see coloured bars showing the current status of each parameter at a glance:
Red: Act immediately – the parameter is significantly outside the optimal range.
Orange: Act soon – the parameter is approaching the critical range.
Green: All good.
There are also the following special states:
All bars greyed out + "Learning…": The sensor was recently connected and is still collecting data – the first full analysis is pending.
Single bar greyed out + "Outdated data": The last data transfer was more than 24 hours ago. Check your sensor connection.
Nutrient bars greyed out + "Info missing": Before a nutrient status can be shown, we need some information about your fertilising activity. Tap the plant to add the missing details.
6 – Garden Selection
Here you can see all your gardens. Tap a garden to show only the plants assigned to that garden.
7 – Filter
Use the filter to narrow down your plant view. The following filter categories are available:
Sort: Sort plant names alphabetically from A–Z or Z–A.
Parameter: Shows only plants that need attention for a specific measurement – for example, only plants that need more or less water. Available for all parameters: Water, Nutrients, Light, Temperature and Humidity.
Status: Filter by the plant's current condition – Happy, Care, Muted, Learning, Outdated Data or Low Battery.
Care need: Shows plants with a specific care requirement – Needs water, fertiliser, repotting or climate stress.
Connection: Filter by connection status – Connected to sensor, No sensor connection, Plants shared with me or Plants shared by me.
8 – Plant Tiles
Each plant is displayed as a tile with its plant image. Tap a tile to go directly to the plant profile. To quickly delete a plant, swipe the tile to the left and tap "Delete".
9 – Plant Name
This shows the name you gave the plant when you created it.
10 – Scientific Name
This shows the Latin name of the plant species.
11 – Additional Information
This is where you'll find notices if something needs your attention or a special status applies:
Info missing: We need some information about your fertilising activity before a nutrient status can be shown. Tap the plant to add the missing details.
Outdated data: The last data transfer was more than 24 hours ago. Check the hub connection or collect data manually.
Low battery: The battery of the connected sensor needs to be replaced soon.
Learning…: The sensor was recently connected – the first full analysis is still pending.